Go to Featured Article:
Checking And Charging Motorcycle Batteries by George Royal

Searching for: plan on how to build a moped

Featured article:
Checking And Charging Motorcycle Batteries

by George Royal

How are Motorcycle Batteries Rated?

The amp/hour (AH) capacity is the basis for rating motorcycle batteries. For example, a 12AH battery can produce one amp of current flow for 12 hours, or two amps for six hours. In order to calculate the amount of time needed to use up a fully charged motorcycle battery by turning the lights on, we have to take power in watts, and divide it by voltage, which gives us the current draw in Amps. Therefore, a 72 watts beam and tail together, divided by 12 volts equals a 6-amp draw. So in 2 hours, the 12AH battery is dead.

Checking Motorcycle Battery:

If you decide to check if your new motorcycle battery is done correctly, follow this actual factory-recommended service procedure.

If the battery is not a maintenance-free type (which doesn't have a vent tube), unwrap the battery, unkink the vent tube and snip about a half-inch off the end. Fill it with electrolyte midway (between the high and low level markings on the case) and leave it undisturbed for one or two hours. Remember, the battery will still be at only 65% of full charge at this point. Add electrolyte again if required.

If your battery is a refillable lead-antimony type, it should be charged at one-third of its rated capacity in amp/hours for four to five hours to get it to full charge. Maintenance-free type batteries should be charged with a constant-current charger that can drive the charge with as much as 16.9 volts. This should be closely supervised so as not to exceed full charge.

Next, recheck the electrolyte level and add water if required. Let the battery cool so the case contracts enough to fit into its typically tight little holder. Run the new breather tube, if the battery comes along with one, carefully through the original factory routing.

Things to Remember when Charging the Battery:

First of all, it is important to remember that Red is positive and Black is negative in order to avoid any accidents such as short-circuits and nasty shocks.
The charger should be compatible with the motorcycle battery, and give a greater output than the battery voltage, but not too high.
Make sure the connections are clean and the electrolyte is at the upper level, and don't fill the cells up to the very top of the battery.
You can either use an optimizer on the battery, which can effectively switch off the battery when it's charged and prevents overheating, or disconnect it manually.
It is recommended to put your battery on charge every two or three weeks.
An upper and lower level battery should have all the cells on the upper level, not over and never under the lower level.
For topping off the low cells, use only distilled water.
The minimum charge for a new battery should be for at least 8 hours.
If you have a dry battery, fill the cells slowly and leave the battery for around half an hour.

Batteries HQ: everything you need to know about batteries.

Other articles you may find interesting:

Motorcycle Belt Tension Inspection, Belt and Wheel Alignment

by Jim Noss

I strongly believe that knowledge is power. Especially when it comes to motorcycle maintenance. Why go to the stress and expense of having your local motorcycle shop perform your maintenance and upgrades when you can learn to do it yourself? And you know that if you do your own maintenance, that you will give the extra attention required to do a competent job. I doubt you can say the same for the underpaid and over-worked motorcycle service mechanic.

The other benefit of doing your own motorcycle maintenance is that you learn more about your bike. This has many benefits. You will be able to tell when
Read this article in full

Installing a Motorcycle Fork Stabilizer

by Jim Noss

The benefits of installing a Superbrace motorcycle fork stabilizer

You may ask yourself, what is a motorcycle fork stabilizer and why do I need one for my motorcycle? These are very reasonable questions to ask, especially since you have expected the motorcycle manufacturer to have given your motorcycle the highest performance suspension components available. I hope to answer these questions and many more within this motorcycle fork stabilizer article.

I first became aware of motorcycle fork stabilizers from the Cycle Solutions (www.CycleSolutions.net) motorcycle forums. Several members of the forum suggested that this was an aftermarket part to install on your motorcycle. Being both curious and ignorant I asked questions. Is this
Read this article in full

What You Need to Know About Spark Plugs

by Maricon Williams

There is much to learn about motorcycle spark plugs. Actually, there is more than meets the eyes.

First, let us distinguish the important difference in spark plugs' threaded ends. They come in four diameters and lengths. They come in nominal 14, 10, 12 and 18 millimeters diameters. previously, there was a slight difference in thread configuration especially in different countries. However, the international standardization of the thread forms made it uniform. These new dimensions are now being followed by motorcycle parts manufacturers.

Common Mistakes

There can be lots of error in selecting the best motorcycle parts, especially in the case of spark plugs. The very usual error is using ¾-inch plugs in ½-inch
Read this article in full

Proper installation of used motorcycle cables

by Granny's Mettle

Part and parcel of owning a bike is maintaining its appearance and its capability. Nevertheless, despite making sure that the parts and cables of the motorcycle give us maximum service, we cannot but accept that they have their own warranties and lifetimes.

Unlike artwork or antiques, motorcycles are made to be used and abused. With all the elements found in the environment, a motorcycle part will definitely have its final day. When that day comes and you don't have enough money to buy new ones, why not settle for used motorcycle parts, e.g. cables? With a little tinkering and proper installation,
Read this article in full

Motorcycle Maintenance Tips: Oil!

by Greg Hudson

Do just about anything to your motorcycle, but forget the most basic and fundamental additive - Oil - and your wallet could be hanging loose for a long time.

How often you change the oil, the level you fill it up to and the kind of oil you use all make the difference between a bike that lasts and a bike that doesn't!

These are a few of the most basic tips when it comes to oil and motorcycles...